106-06-1 LN Engineering 160F Low Temperature Thermostat Insert MY97-08 M96/M97

$78.00
SKU
106-06-1

106-06-1 LN Engineering 160F Low Temperature Thermostat Insert MY97-08 M96/M97

106-06-1 160F Low Temperature Thermostat Insert MY97-08 M96/M97

Did you know the factory thermostat doesn't start to even open until 186.8F and doesn't fully open until almost 210F? This causes hot spots inside your engine that can result in cracked heads and cylinder failures from overheating. Our 160F low temperature thermostat is not available from any other vendor and features a calibrated, German-made 160F thermostat. It is calibrated to allow thermostat opening a full 20-25F degrees earlier than the factory thermostat.

That means that the the low temperature thermostat is designed to be fully open by 180-185F, allowing for full flow to the cooling system to maximize cooling potential. With high on-track water and oil temperatures, the 9A1 engine can use every bit of cooling it can get.

The LN Engineering thermostat is the only one used and recommended by Stoddard and should be installed anytime a new Genuine Porsche water pump is installed, which should be replaced no later than 4 years or 50,000. Please be sure to remove your bumper cover and clean out your radiators for maximum cooling benefit!


Application note: Even if you have cleaned out your radiators, please be advised, some late-model cars do not report actual coolant temperature, so some users will not see any visible change in operating temperature when fitted with a 160F low temperature thermostat.

Replaces Porsche part numbers 996 106 125 52 (53). Does not fit GT2, GT3, or Turbo models.

 *Thermostat housing gasket sold seperately*

More Information
SKU 106-06-1
© 2020 Stoddard NLA LLC. All Rights Reserved.